Guide :Food Mixers : Attrezzi JSM900 Stand Mixer

Changed bulb and light still not working

I changed the flourescent bulb in the under cabinet lighting and the light bar still doesn't work. I replaced it with the same bulb I took out, except that the new bulb had green ends and the old one had silver ends. I put in 15W 12inch bulb and turned it in the ballast (I think that's what the part is called that they slide into) until I felt the "snap". I did not re-install the guard, but I can't see that being an issue. The unit is hard-wired and operated by a wall switch. I took the bulb out and tried turning it the opposite way, as well as flipping the bulb and turning it both ways u

Research, Knowledge and Information :


10 Reasons Why Your Lights Don't Work - Networx


10 Reasons Why Your Lights Don't Work ... But what happens when a trusty fixture suddenly fails to light our way? Is it a bad bulb? Is it a wiring problem?
Read More At : www.networx.com...

I already changed my tail light bulb and still its not working


I already changed my tail light bulb and still its not working - Answered by a verified Mechanic for Honda
Read More At : www.justanswer.com...

I have replaced the bulbs (brake light still not working)


How JustAnswer Works: ... I have replaced the bulbs (brake light still not working) ... There is a parking light bulb and a brake light bulb .
Read More At : www.justanswer.com...

Turn signal out - not the bulb or fuses. Any ideas?


Can anyone help me with this diagnosis and fix? Right turn signals (front and back) and right emergency flashers are not working. The bulbs are fine, based on the ...
Read More At : ths.gardenweb.com...

electrical - Lights not working after replacing blown light ...


Lights not working after replacing blown light bulb. ... Porch lamp outside house not working, and changing bulb ... If a light bulb is dead, does it still consume ...
Read More At : diy.stackexchange.com...

Fluorescent Lights Not Working | ThriftyFun


My bathroom light stopped working, so I changed the fluorescent out with a new one, but still it doesn't work. It only glows on one end after I touched it with my ...
Read More At : www.thriftyfun.com...

How To Diagnose Brake Light Problems - AGCO ... - AGCO Automotive


If it too is not working, the brake-light ... the third-light should still ... My driver's side brake light went out. Changed bulb and then it only works when I ...
Read More At : www.agcoauto.com...

How to Fix Brake Light Bulbs - 2CarPros


How to Fix Brake Light Bulbs. ... If the light is still not working after replacing the bulb or it is dull or dim then more repairs are needed so continue with the ...
Read More At : www.2carpros.com...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.foodcookingmixer.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0556 seconds